Welcome to visit Shandong Jiankun Robot Co., Ltd. (Linyi Jiankun Intelligent Technology Co., Ltd.)

Home

Round pipe

Release time:

Mar 30,2026

The pipe diameter can be adjusted here, and this part can move up and down—make sure it is clamped at the center height.

This is the clamping method for round tubes, which requires extending the fixture into the tube and then expanding it to secure the clamp—this applies to rectangular tubes as well.

H-shaped steel channels all extend inward and brace outward.

The pipe diameter can be adjusted here, and this part can move up and down—make sure it is clamped at the center height.

When clamping from the front, regardless of the profile type, make sure all four clamping bars are firmly pressed against the profile. If they are not properly aligned or fully secured, impact may occur during cutting.

Import the corresponding process, then turn on the laser power supply and the optical shutter. For all our profiles, manual centering is crucial; be sure to set the horizontal alignment.

Place the material just below the cutting head, leaving a small margin, then zero the workpiece and start cutting.